Complete the following general steps to configure the DHCP solution for this lab:
1. Create the Building 1 (include the space between "Building" and "1") scope on Sea-It-Sub2 for addresses 192.168.10.51 to 192.168.10.250. Exclude addresses 192.168.10.51 to 192.168.10.210.
2. Activate the scope.
3. Add the Sea-It-Srv1 server to the DHCP console.
4. Create an exclusion on Sea-It-Srv1 for addresses 192.168.10.211 to 192.168.10.250. …show more content…
Create a Scope
1. In the DHCP management console, open the DHCP server.
2. Right-click the protocol for which you wish to create the scope and choose New Scope....
3. Click Next to start the New Scope wizard.
4. Name the scope, then click Next.
5. Type a start IP address and an end IP address.
6. Set the subnet mask by typing the mask value (example: 255.255.255.0) or typing the number of subnet mask bits (example: 24) in the Length field.
7. Click Next.
8. Type the starting and ending IP address for any exclusions. (Note: To exclude a single address, type the start address but leave the end address blank.) Click Add.
9. Click Next when you have defined all required exclusions.
10. Configure the lease duration. Click Next.
11. Select the No, I will configure these options later option to postpone configuring other DHCP options, then click Next.
12. Click the Finish button to close the wizard and create the